12V 2000A Peak Current CarKu Jump Starter for Tanks

2000Amp peak current and 1000A start current lithium jump starter EPower-99A is extremely  powerful to start all vehicles 12V or 24V, even tank. Handheld jump starter is easy to take it out from your vehicle when you need it.  It is much less lighter and longer life cycles than the lead acid battery jump starter. Nowadays, lead acid battery heavy duty jump starter is gradually replaced by lithium battery jump starter in the automotive industry.  If you are running car repair store or sell professional automotive tool, why not try it?

20180124131731_89282.jpg

CHARGING XX%

Shows up the percentage of being charged when it is connected to 230V power supply

 

BATTERY XX%

Shows up the amount of internal battery capacity. At least 60% are recommended to jump start a car.

 

LOW BATTERY RECHARGE NOW

Indicates low battery, please recharge.

 

USB1 USB2 ON

USB port 1 and 2 are available to recharge mobile USB devices

 

WARNING CLAMPS REVERSED

Shows that the clamps are connected reversely. At this time the start is prevented. Please remove the clamps and connect them in the right way. The red clamp must be connected to the positive (+) terminal and the black clamp to the negative (-) terminal of the battery. If you are sure that the connections are correct but this warning still shows up, press the Power button for three seconds to ignore this warning.

 

SHORT CIRCUIT CHECK ALL CONNECTIONS

It indicates a short circuit. At this time the start is prevented. Please remove the clamps and press the power button for three seconds before reconnecting the clamps to the battery.

 

12V JUMP START READY

Shows up when heavy duty jump starter EPower-99A is connected to a 12V battery and is ready to jump start. If EPower-99A cannot detect the battery or the battery is too low to be detected, you may use the “Expert Mode” for manually choosing your 12V battery type and jump start your 12V car battery.

 

24V JUMP START READY

Shows up when EPower-99A is connected to a 24V battery and is ready to jump start. If EPower-99A cannot detect the battery or the battery is too low to be detected, you may use the “Expert Mode” for manually choosing your 24V battery type and jump start your 24V car battery.

LED Flashlight:

the lumen of led light is 3W, and there are three modes: lighting, strobe, and flashing. Please press the button on the front till 3 or 5 second to see the lighting. If you want to change the any of these mode,you can press it at one time.

Accessories:

 

  • 3 in 1 USB cables

  • Home Charger

  • Smart jumper cable

  • Manual

 

How to jump start lithium battery starter charger EPower-99?

 

  1. Make sure the battery is not less than 60% shown on the LCD display.

  2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK clamp to the vehicle's battery negative (-) terminal.

  3. When you use EPower-99 jump start 12V car, it displays "12V JUMP START READY", when you use EPower-99 jump start 24V car, it displays "24V JUMP START READY".

  4. Start the vehicle.

  5. When the vehicle is restarted, please remove the jumper cable from Jump Starter and remove RED and BLACK clamps from the vehicle battery.

20180124131828_85673.jpg